Installation height of wall bases
Installation of wall brackets
Seitenansicht
s shown in the figure, we recommend making
the awning surface to form an angle of about 80
degrees with the wall when it is open .
Determine the wall bracket installation height (C)
by the formula C=A + 0,17xH .
A = is the preferred height of front profile.
Moving parts of the drive must be installed
higher than 2.5m above the floor or other
level that could provide access to it.
H = is the maximum projection lenght of shade
(H), obtainablefrom specification of the awning
17 is the adjustment figure at our recommended
angle of inclination of 80° .(If you prefer using the
awning with smaller inclination angle ,you can
replace the figure with 0.5 for inclination angle
of 60° and with 0 .71 for the maximum inclination
angle of 45°) .
The holes of each group must be on the same line in transversal direction and
vertical direction .
Mark the height on the wall and locate the drill hole positions for the wall brackets .
Drill the holes with masonry drill of 12mm diameter,The depth of the hole is
above 110mm . Please note that the depth of the holes shall leave the threaded
part of the central bolt extruding from the wall .
bolt
Expansion
Washer
Nut
Bolt
The nut and washer might be separated from the bolt during the process
of transportation, please put them back into their original positions before
hammer them into the wall during installation.
20