SEAT(S)
Attach the seats by attaching the seat connectors [17-20]. The top connectors
attach to the forward D-rings and the lower seat straps connect to the rear
D-ring connectors. You have been provided with an extra cushion block which
is attached by Velcro to the bottom of the seat [22]. To see if the seat is at the
right height, place your weight on the seat pushing your lumber region into
the backrest by arching your back forward then sit up straight. You want to
feel supported and steady. If you are using the cushion block and the seat is
slipping or moving around then the seat is set too high so remove it [23]. The
seat should be set and adjusted to give you the best support and balance whilst
paddling. You have been provided with an additional velcro strap which you can
use as a footrest [21].
SKEG/FIN
Turn the Kayak over
and slide the skeg/
fin into the base
[24-25]. It will only
slide in one way.
Slide the locking
tab into its groove
until it clicks into
place [27-29].
PADDLE
Assembly for the paddle is straight forward, begin by connecting the halves by
inserting the half with the push pin into the half with the holes.
DEFLATION
Make sure that the kayak is fully dry before folding and stowing.
Remove all seats, skeg/fin etc. [33] Push down on the valve stem and quarter
turn to the right. The valve will stay in the down position allowing the air to
escape [34].
WARNING: DO NOT PLACE FACE DIRECLY OVER VLAVE AS AIR ESCAPES
AT FORCE AND COULD BE DANGEROUS.
Once you have removed most of the air you can use the pump by changing the
outlet pipe (‘IN’) [35] and pumping out the last of the air [36-37]. Once you have
completely deflated the kayak fold the walls over the floor so that the kayak is
a
a
a
a
b
b
b
b
17
18
19
20
21
22
23
24
27
25
28
26
29
30
31
32
36
40
35
39
34
38
33
37
4
IN
