THROUGH-HOLE LED MODULE
CS20
7
+86-28-8148 0011
+86-28-8148 1258
Add:No.1000,Section 2,2nd Konggang Road, Southwest
Aviation Industrial Development Zone,Chengdu,Sichuan,China.
ZIP:610207 Web.:www.blueviewled.com
Specifications are subject to change without notice.
Blueview 2020-All rights reserved.Made.in China.
®
Warning
Do not disassemble or retrofit the light. Do not touch the surface of the light with a sharp object.
Do not do live-line working during installation,especially for high voltage product.
Do not use any organic chemical solvents.
Use neutral glass adhesive to fix this product and it needs to be dried 4 hours in the open environment after operation.
Treat the ends and the circuit connection points that are not connected to the main line with insulation,waterproof, and anti-corrosion in the installation.
Use 18AWG (0.75mm² cross-sectional area) or thicker core wire to avoid adverse consequences caused by overheating, if the power cable need to lengthen.
Make sure the input voltage meets the requirements and lines are connected correctly before lighting on.
This product is for signage, and do not use as general lighting.
Series connection within the max run.
The length of the power cable between the power supply and the led strip should not exceed 2 meters.Otherwise, large circuit loss will lead to inconsistent
brightness.
Installation, maintenance and repair should be operated by a qualified technician.
■
■
■
■
■
■
■
■
■
■
■
Quick Guide
Problems
All LEDs can not light on.
LEDs can not light
on partly.
Brightness of LED is
inconsistent
tor insufficient.
LED flicker.
Automatic power protection from the open or short circuit
in output of the power supply.
Fix the short circuit problem.
Correctly connection
Check the power supply system to fix it.
Replace with more powerful power
Make sure the working voltage of the product within ±5% of standard voltage, or
keep balance by circuit power consumption.
Reduce the quantities of the product in series connection to meet requirement.
Power on
Wrong connection of power supply.
Some switching mode power supplies are not powered.
Power supply line error.
Mistaken wire connection of some of products
Power overloaded.
Connection point fault.
Remove bad connection point.
Replace a new power supply.
Please follow the instructions
Power supply circuit excessive consumption.
Excessive quantities in series connection of the product
Switching power supply failure.
Wrong Installation or use of products
Reasons
No electric supply.
Solutions
Common Faults and Troubleshoot
Statements and Recycling
Repair should be operated by a qualified technician, if the external circuit or main line of this product is damaged.
The parameters given in this manual are typical values and for reference only.
All illustrations and drawings in this manual are for reference.
This product is subject to change without notice.
Statements:
LED lighting products belongs to electronic products, please do recycling treatment according to the relevant WEEE directives.
Recycling:
■
■
■
■
■
