HEX70ED
USER MANUAL
04
www.bluestream.co.uk
HEX70ED
User ManUal
04
contact
Panel Description HEX70ED-TX
HEX70ED-Tx
Transmitter
1
1
2
3
4
5
6
2
3
4
5
1
RS232 connector
2
HDMI input (Source input)
3
HDMI link indicator
4
IR RX jack (For IR sensor)
5
IR TX jack (For IR emitter)
1
EDID DIP switch ( UP=0, DOWN=1)
2
Upgrades DIP switch
3
Signal Link indicator
4
HDBT output
4
Power status indicator
6
DC 12V screw type connector
[DIP]=0000:
HDMI 1080p@60Hz, Audio 2CH PCM
[DIP]=0001:
HDMI 1080p@60Hz, Audio 5.1CH PCM/DTS/DOLBY
[DIP]=0010:
HDMI 1080p@60Hz, Audio 7.1CH PCM/DTS/DOLBY/HD
[DIP]=0011:
HDMI 1080i@60Hz, Audio 2CH PCM
[DIP]=0100:
HDMI 1080i@60Hz, Audio 5.1CH PCM/DTS/DOLBY
[DIP]=0101:
HDMI 1080i@60Hz, Audio 7.1CH PCM/DTS/DOLBY/HD
[DIP]=0110:
HDMI 1080p@60Hz/3D, Audio 2CH PCM
[DIP]=0111:
HDMI 1080p@60Hz/3D, Audio 5.1CH PCM/DTS/DOLBY
[DIP]=1000:
HDMI 1080p@60Hz/3D, Audio 7.1CH PCM/DTS/DOLBY/HD
[DIP]=1001:
HDMI 4K2K, Audio 2CH PCM
[DIP]=1010:
HDMI 4K2K, Audio 5.1CH PCM/DTS/DOLBY
[DIP]=1011:
HDMI 4K2K, Audio 7.1CH PCM/DTS/DOLBY/HD
[DIP]=1100:
DVI 1280x1024@60Hz, Audio None
[DIP]=1101:
DVI 1920x1080@60Hz, Audio None
[DIP]=1110:
DVI 1920x1200@60Hz, Audio None
EDID Control
EDID (Extended Display Identification
Data) is a data structure that is used
between a display and source. This data is
used by the source to find out what audio
and video resolutions are supported by
the display then from this information the
source will determine what the best audio
and video resolutions are to be outputted.
While the objective of EDID is to make
connecting a digital display to a source
a simple plug and play procedure issues
do arise when multiple displays or video
matrix switching is introduced because of
the increased number of variables.
By pre-determining the video resolu-
tion and audio format of the source and
display device we can remove some of
the EDID hand shaking process thus mak-
ing switching quicker and more reliable.
Instructions on these setting can be found
on the right
NOTE:
The port will only read the DIP switch settings
on power-up. The device must be powered off and
then back on again for it to implement any change
of the DIP switch settings.
