If it is still not working after the inspection by yourself, please immediately contact
our service points, do not apart the unit by yourself or our company is out of respon-
sibility.
DO NOT TRY TO ADJUST OR REPAIR THIS APPLIANCE BY YOURSELF.
The wall at the top of working face and the wall near the induction cooker must be
protected against heat.
Laminates and adhesives used to install them must also be heat-resistant so as to
avoid changes.
In any installation mode, we should ensure that the ải behind the furnace and the
rear side ò the furnace can reliably dissipate heat, thereby increasing the electro-
magnetic cooker. Work reliability.
Protect the opening: if it is in contact with moisture, the laminates used for work-
able fabrication are relatively easy to expand. Smear on the edge of the opening
Varnish or special adhesive to prevent condensation of any steam under the work-
ing bench.
According to the specified size, open a square hole on the worktable to ensure
that any side is larger than 100mm from the wall.
Under various installation conditions, the induction cooker needs good ventila-
tion to ensure that the inlet and oulet are not blocked.
No other equipment should be installed in the range of 50cm around the induc-
tion cooker working face and above the working face.
INSTALLATION
INSTALLER STEPS
1
Cut out the work surface according to the sizes show in the drawing (Figure 1)
TABLE SURFACE
LEFT
RIGHT
FRONT
BACK
Hole size: 670x400mm
Hole deep: 100mm
670mm
400mm
ENGLISH
ENGLISH
24
25
