Please make sure that you read these instructions carefully in order to avoid injury when using
the coil spring compressor. Follow all health and safety rules and regulations. If in doubt and
available please contact a more knowledgeable source.
It is inadvisable to leave a coil spring under tension due to the stored energy. Immediately
replace the coil spring onto the shock absorber in order to reduce time that spring is under
tension away from the vehicle and potentially a danger to you or anyone in your workshop.
DO NOT use if damaged.
•
Maintain tool in good and clean condition for best and safest performance.
•
Keep the work area clean, uncluttered and ensure there is adequate lighting.
•
Maintain correct balance and footing. Ensure the floor is not slippery and wear
non-slip shoes.
•
Keep children and unauthorised persons away from the work area.
•
If the spring compressors are damaged do not use.
•
ALWAYS
dress appropriately – clothing should be close fitted and long hair tied back.
Jewellery should be removed and shoes should be worn with a non-slip sole.
•
ALWAYS
wear the correct eye or face protection when operating the spring
compressors.
•
ALWAYS
wear approved respiratory protection if needed.
•
ALWAYS
ensure you work in a well ventilated room.
•
ALWAYS
ensure the coil spring compressors are used as a pair.
•
ALWAYS
tighten and release the spring compressors evenly and slowly.
•
BE AWARE
only to use hand tools to tighten/release the spring compressor.
•
ALWAYS
ensure the locking pins have secured the spring in place before use.
•
ALWAYS
check and ensure the hooks are connected securely on the spring before
commencing compression.
•
DO NOT
allow for the spring to become coil bound.
•
DO NOT
leave a compressed spring unattended.
•
NEVER
use air tools to compress a spring.
02
Safe use
(continued)
•
NEVER
operate the tool if you are under the influence of drugs or alcohol as this
is dangerous.
•
NEVER
make modifications to the tool.
•
NEVER
use the spring compressor for a task that it was not designed for.
•
DO NOT
operate the spring compressors if you are tired as this could be dangerous.
•
ALWAYS
stop using the tool straight away if you start to experience discomfort or pain.
Consult with a qualified health professional if needed.
The BlueSpot 2 PCE Heavy Duty Pin Type Coil Spring Compressor is an essential tool for quickly
and securely compressing springs on vehicles when repairing or replacing the shocks, springs or
struts. Manufactured from heat treated carbon steel for increased durability. Suitable for use with
coil springs with a diameter less than 16mm.
These coil spring compressors feature a heavy duty hook with an extra safe pin that locks onto
the spring to give you an additional level of safety when compressing the spring.
Introduction
Parts Diagram
3
4
2
1
1
2
3
4
Locking pins
Screw thread
Thread puller hook
Non-Threaded puller hook
