601-01800-M01
3
Dropped Ceiling Installation
Tools Required:
- Utility knife
- 6 inch Phillips head screw driver
- 12 inch metal ruler
- Pencil
1.
Remove tile from suspended ceiling. Flip tile so you are looking at the
back (unfinished) side. Draw a 9in x 9in square at the desired location.
Using the utility knife and the metal ruler, carefully cut out the square.
Smooth out any rough edges on the front (finished) side of the tile. The
cut tile should look like the picture below.
2.
Fasten the rear mounting bracket to the bottom of the BSAP-18XX using
2 M2.5x7mm screws as shown below.
