Do Not Duplicate, Alter, or Copy without the Express Written Consent
of BlueSky Mast, Inc. Copyright 2013 Allendale LLC All Rights Reserved
AL3 Lift Series - Deployment Quick Reference Sheet
Read Manual Before Use
Refer to detailed instructions in the
AL3 Lift Series Manual at all times
Pass the cable through the 2
rollers on the lift base plate.
Pull the pin to secure the ball
stop. Confirm the cable is taut
and the lift base plate is secure.
Attach the winch handle. Pay out
the cable by turning the winch
handle counter clockwise
The cable should hang freely on
the left side of the winch and
should not go over anything.
Locate the
LIFT BASE PLATE
and insert it into the bottom of
the mounting pole.
Loosen the turn knobs on the
STRUTS
and extend them
towards the strut base plate.
DO NOT
loosen the turn knobs
on the tripod legs.
Locate the
STRUT BASE
PLATE
and place it directly
under the tripod.
Release the Velcro strap hold-
ing the tripod struts on each of
the 3 tripod legs.
Center the strut base plate
under the tripod and align with
the 3 tripod struts.
Stand the tripod up and release
the large Velcro Strap at the
bottom.
Open the tripod legs and lock
the cross bars. Push them all
the way down to fully engaged.
Stake ONLY the LEFT HOLES
on the base plates of the 2
extended tripod legs.
Insert the mounting pole until 1
hole is showing below the cam
lock and lock the cam lock.
Level the tripod by adjusting the
tripod legs. Make sure all 3
bubble levels read level.
Stake the remaining holes on all
3 tripod legs.
Add the
Blue Secondary Guy
Ring
then the
Red Primary Guy
Ring
.
DO NOT
secure them.
Mount your equipment to the
mounting pole, connect and
secure all cables.
Extend the tilt leg and tighten
the turn knob. Make sure all
tripod struts are facing inward.
Extend the 2 tripod legs adja-
cent to the winch. DO NOT
extend the tilt leg at this time.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
9
03
/1
6
