10
Battery LED indications
#
LED
INDICATION
EXPLANATION
Steady Red
There is no AC present
1
AC
Steady Green
There is AC present
2
Bat #1
Bat #2
Steady Green
Battery is full
3
Bat #1
Bat #2
Flashing Green AC is not present and the blinking channel is ready to
power or is actually powering the load on the AUX port
4
Bat #1
or
Bat #2
Flashing Orange
The battery is in charge and is charging at less than
1000mA.
Two possible conditions:
1.
The battery is in pre-charge mode because of low
voltage, and is limiting the charging current
2.
The load connected to AUX is absorbing current
available and therefore there is not enough power
to charge the battery at full rate. The available
power is shared between charging and AUX
power and the charging current is reduced.
5
Bat #1
Bat #2
Steady Orange
Battery is in constant current (CC) phase
6
Bat #1
Bat #2
Flashing
Orange-Green
Battery is in constant voltage (CV) and has just reached
the ~90% of capacity, and is completing the charge
7
Bat #1
Bat #2
Flashing Red
Premature charge termination - the battery stopped
before it was supposed to. This may be due to the
battery not enabled to charge for a temporary condition.
The charger will keep retrying every 30 seconds for
approximately 2 hours.
8
Bat #1
Bat #2
Steady Red
Battery failure: several causes.
The battery should have charged but did not after 2
hours of retrying because of an internal failure.
The battery ID resistor is incorrect and not recognised.
(applicable range is 10K<ID<60K)
9
AC
Bat #1
Bat #2
Flashing Red
All the 3 LEDs flashing together.
Operation halted because charger has overheated. The
charger will automatically resume operation when it
cools down.
