1 0 ” Z 1 T E L C O R E D R I L L
9
Ø
The main machine with it’s own secondary stand is connected to the primary stand using the round slotted
backer on the drill body. It is bolted down using two of the short bolts with washers (one on each side). If
planning to tilt the drill horizontally to the right, you would attach one bolt/washer on the left in the bottom
bolt hole and the bolt/washer on the right side through the top bolt hole as pictured below. If you are
planning to tilt the drill horizontally to the left, you would use the left top and right bottom bolt holes
opposite below. When your angle is set, tighten the bolts.
TRANSPORTING THE MACHINE
Ø
When transporting the machine, always use two hands.
Ø
DO NOT transport the machine with bits in the spindle.
Ø
If transporting inside a vehicle, it is recommended to transport it on its side so as to avoid the item falling
over.
Ø
DO NOT carry the machine by the cord.
