at 33 rpm the belt is cantered on the platter edge. The
approximate right position of the spring supports are:
(considering the turntable front view) LEFT at the same
level of the tip of its threaded bar; RIGHT 5mm higher
than the tip of its threaded bar; BACK 8mm higher than
the tip of its threaded bar
•
The Turntable is not levelled
•
Be sure that the turntable layer is enough solid
and rigid to support the weight of the turntable easily
SPEED ADJUSTMENT ON THE
ADJUSTABLE ALUMINIUM PULLEY
•
The aluminium adjustable
pulley doesn’t spins at the right speed
•
With the help of a “coin” screw clockwise or
anti-clockwise the pulley’s internal cone to increase
(clockwise) or decrease (anti-clockwise) the speed.
Check the right speed with a proper stroboscope
SPRING ADJUSTMENT
•
It is hard to adjust the springs
inserted in the bolt shaped supports bear
the black curved board
•
To help the adjustment of the springs through
their bolt shaped spring supports, slightly lift the black
board (few millimetres) with a finger during the rotation
movement of them.
VTA ADJUSTMENT
•
VTA tone arm is not adjustable
•
The arm board collar hex bolts are screwed into
the collar too much and do not let the arm shaft gets in it;
unscrew the hex bolts properly
•
VTA tone arm is not adjustable
•
The adaptor has to be used and lift but the collar
keeps it down; Unscrew the collar hex bolt, find the proper
adaptor height and re-fix it again
•
VTA tone arm is not adjustable
•
The tone arm shaft is too big to get into the
collar or the supplied adaptor; ask your local dealer to have
a custom made collar fit such arm
•
VTA tone arm Hang Over is
hard to adjust
•
With the Bluenote arms or Rega standard shaft
ones, rotate the adaptor at the necessary height, till the
proper Tonearm Hang Over is been found
CLEANING THE TURNTABLE
•
The Turntable is dirty and needs
to be cleaned
•
With EXTREME care use ONLY pure alcohol
and a very soft 100% cotton cloth to sweep dust and stains
out.
Any acid or not extremely soft cloth will irreversibly
damage the turntable fine aesthetic.
Do not use any alcohol to clean the turntable anodised
label, pulley and motor spindle. Only dry cloth is allo wed
F.A.Q. & Adjustment
12