BlueDimension PARSEC, Instructions Manual

Page: 2 / 12

Before any use of this product, please read the instructions carefully. This is not a toy (it is not
suitable for children under 12 years) and should be treated accordingly. Any improper use or
installation could cause irreversible damage to your product and in that matter, BlueDimension
does not take any responsibility. These instructions are updating on the website (revision and
publish date are on the first page) and you should check to ensure to have the newest version.
Please read terms and conditions as well as warranty before installation.
This product will get hot and can burn you, so please do not assemble or disassemble it, while
the computer system is running, or you can get hurt and/or even electrified or you can damage
your computer components beyond repair.
•
Read the instructions carefully before use!
•
With the use of this product, you also agree with Terms and conditions.
•
Use of the rubber gloves is recommended, to protect the surfaces of products.
•
To remove later problems, a test loop is recommended to check, if there are any problems
regarding leaking and electronic faults. But never run a loop without a coolant, or you can
damage components, especially the pump!
•
To ensure ease of work, please remove any PCI-E expansion cards (especially GPU), to
have the most working area and to prevent any mechanical damage to your cards.
•
Any screws on water-blocks should NOT be tightened too firmly, or you can damage
threads and/or the water-block itself, thus preventing a tight seal. Any cracks or leakage
happening due to overtightening, is user fault and it is not covered in warranty!
•
Outer fittings ring does not require extensive force and should be tightened only by hand.
Any use of tools, such as wrench or pliers, can cause screws to be overtightened and
damage the water block or sealing ring. Damaging your components, because of the
extensive force, will void your warranty!
•
Thermal paste must be used between CPU/GPU surface area and water-block to ensure
proper contact conditions.
•
Only distilled water can be used as a coolant to prevent impurities in a loop.
•
Never run your loop without any coolant, or you can damage your components, especially
the pump!
•
Removing air bubbles from the loop (air bleeding) is recommended to ensure best possible
performance.
•
This water block is not intended to use on a CPU without IHS.