12
ContRols
Steering/Locking Handle
located at the rear axle. lift and rotate the lever
clockwise to steer unit and counter clockwise to lock
steering.
Handle Lock
Pull and hold lever, raise or lower the handle to
desired position, then release lever. The lever can be
locked back to allow a “floating” handle position if
desired.
Throttle Lever
Pull right pistol to apply full throttle. The engine has
a contained centrifugal clutch—increasing engine
rPm above 2000 will engage the drive. releasing the
throttle lever brings engine back to idle speed and
disengages drive.
Depth Control Setting Plate
Three depth positions are available, 2", 3", 4" deep.
Choose a depth position setting and pin axle lock in
desired position. Place the unit into transport position.
Pull the clevis pin out and slide the height plate until
the desired depth lines up with the 2", 3" or 4" deep
decal. replace the pin, the ½" pin should line up with
the desired setting.
