Page 18
Sonic-Pro
Industries, Ltd.
Industries, Ltd.
ProSeries
by Blue-White Ind.
TM
The Sonic-Pro Flowmeter is shipped in a carrying case. Inside the carrying case you will
find the following items:
Sonic-Pro Flowmeter SPU (Signal Processing Unit)
Sonic-Pro Transducer Set
Enclosure Mounting Hardware
2 mounting plates
4 mounting plate screws (10-32 x .50”)
4 panel mount screws (8-32 x 3.00”)
2 wall mounting screws (#10 x 1.00”)
1 panel mounting gasket
1 pipe mounting clamp
Transducer Mounting Kit
2 blue gaskets (single use)
2 white gaskets (multi use)
2 sound dampening pads
4 transducer mounting clamps (long)
Paper Instruction Manual (English)
CD
!
!
!
!
!
!
Instruction Manual (English, Spanish, German, French)
Select a mounting location for the SPU t
can be mounted on a wall, on a horizontal or vertical run of pipe or in panel.
Although the Sonic-Pro
The Sonic-Pro was designed to be installed and operated by qualified personnel only. Do
not attempt to install or operate the meter if you are unsure. Seek qualified assistance.
Please note that warranty coverage does not include damage due to misuse or
improper installation.
hat is within reach of the transducer cables and
power supply. The standard transducer cable length is 10 feet and must not be cut or
modified. Note that the Sonic-Pro can accurately measure flow from either direction.
The SPU
is designed to withstand outdoor conditions. A cool, dry location,
where the unit can be easily monitored is recommended. Special ventilation is not
required.
3.0 Flowmeter SPU Installation
3.1
Unpacking
3.2
Select a
Mounting
Location
3.3
Wall
Mounting
1) The SPU must be installed on a
solid, secure surface
such as a
solid
wall, panel, wall studs, etc. DO NOT
install the meter on drywall with anchor
bolts.
2)
Measure and mark the distance between
the keyhole slot centers as shown.
3)
Drill two 5/32” diameter pilot holes.
Install the enclosed #10 x 1.00” screws
into the wall. Leave the screw heads
away from the panel surface
approximately 1/4”.
4)
Hang the SPU enclosure on the screws.
4.68 (119mm)
!
CAUTION
risk of danger
Do not position the equipment so that it is difficult to disconnect the power
supply cord.
