14
FILTRATION SYSTEM, WATER INTAKE, AND RETURN FITTING INSTALLATION
IMPORTANT:
BEFORE ADDING WATER TO YOUR POOL YOU MUST INSTALL THE POOL WALL
FITTINGS OR ENTIRE FILTRATION SYSTEM FIRST. BEFORE ADDING ADDITIONAL WATER TO YOUR POOL
FOLLOW THE INSTRUCTIONS IN THE FILTER MANUAL THAT CAME WITH YOUR FILTER SYSTEM.
ALL WATER INTAKE AND RETURN DIAGRAMS WILL BE DETAILED OUT IN THE FILTER MANUAL. THIS WAS
PROVIDED IN YOUR POOL PACKAGE.
FILLING THE POOL WITH WATER
• Before completely filling the pool with water, thoroughly check to see if there are any leaks in the liner, filter
systems, hoses, water intake, return fittings, or the drain assembly.
• Fill the pool until the water is a minimum of 6-in (15-cm) from the top of the pool wall (see diagram 7). This will
ensure the water is entering the intake fitting and flowing into the filter system.
WARNING!
To avoid pool wall collapse, never leave the pool empty without water!The warranty
does not cover damage to an empty pool.
WARNING!
The filter pump must be switched off whenever there are swimmers inside the pool.
WARNING!
Do not overfill the pool or allow people to lay over or sit on the pool frame.
DOING SO CAN
CAUSE THE WALL TO COLLAPSE CAUSING PROPERTY DAMAGE OR SERIOUS INJURY.
Make sure the pools waterline is
at least 6-in (15-cm) below the
top of the pool wall.
(Diagram 7)
