4
USING YOUR SAUNA & ASSEMBLY INSTRUCTIONS
1.
Unfold both side walls of the sauna and stand upright.
2.
Open the front zipper and place the floor cover on the floor over the foot heater.
3.
Unclip the bottom support rods and connect to help support the walls.
NOTE:
You may connect the top support rods after getting in to make it easier to enter.
NOTE:
See Figures 1 and 2 on the following page for images of the connection rods.
4.
Plug the power cord into an electrical outlet
5.
Put the folding chair on the rear part of the cushion facing forward. The unit is now ready
for use.
6.
Use the hand-held controller to set the time and temperature.
7.
We recommend pre-heating the sauna for five minutes.
8.
When the time and temperature has been set, it’s recommended to drink a cup of water.
Then sit in the sauna, close the zipper, and relax.
9.
After using the sauna, make sure to unplug the power cord.
10.
When setting up or taking down, always keep away from sharp objects that may
damage the unit.
Reverse set-up procedures when closing for storage.
