BLUE STONE ICB-6823, User Manual

Page: 12 / 14

If it is still not working after the inspection by yourseft, please immediately contact
our service points, do not apart the unit by yourseft or our company is out of
responsibility.
DO NOT TRY TO ADJUST OR REPAIR THIS APPLIANCE BY YOURSELF.
Cut out the work surface according to the sizes show in the drawing.
For the purpose of installation and use, a minium of 5 cm space shall be preserved
around the hole. Please select the heat-resistant and insulated work surface material
to avoid the electrical shock and larger defomation caused by the heat radiation
from the hot plate. The thickness of the work surface is at least 30mm.
The safety distance between the sides of the hob and the inner surfaces of the
worktop shout be at least 3mm and maximum 1cm.
Display shows E6 High temperature of IGBT. Touch “ON/OFF” button to
restart unit. Wait for the
temperature of IGBT return
to normal.
Check whether the fan
runs smoothly;
if not , replace the fan.
Display shows E7 or E8 Supply voltage is below/
above the rated voltage.
Please inspect whether
power supply is normal.
Power on after the power
supply is normal.
Display shows Eb Ceramic plate temperature
sensor failure-invalid .
Check the connection or
replace the ceramic plate
temperature sensor.
INSTALLTION
TROUBLE SHOOTING
The case below do not mean the appliance breaks down, please check by yourseft
before sending to repair.
MALFUNCTION REASON INSPECTION
No beep, all indicator
lights and nixie tube are
not bright.
No power. Plug in or not? Power
off or not? Power cord is
okay?
The touch controls are
unresponsive.
The controls are locked Unlock the controls. See
Section “Locking the
control” for instruction.
The touch controls are
difficult to operate.
There may be a slight film
of water over the controls
or you may be using the
tip of your finger when
touching the controls.
Make sure the touch control
area is dry and use the ball
of you finger when touching
the controls.
Some pans make the
crackling or clicking noises.
This may be caused by
the construction of your
cookware. (layers of different
metals vibrating differently).
This is normal for cookware
and does not indicate a
fault.
The glas is being sratched. Rough-edged cookware.
Unsuitable, abrasive scourer
or cleaning products being
used.
Use the cookware with flat
and smooth base.
The glass is broken. Heating with higher power
and dry the food for a long
time.
Do not dry the food for a
long time.
Display shows E1 or E2 Ceramic plate temperature
sensor failure-open circuit/
short circuit.
Check the connection or
replace the ceramic plate
temperature sensor.
Display shows E3. High temperature of ceramic
plate sensor .
Touch “ON/OFF” button to
restart unit. Wait for the
temperature of ceramic
plate return to normal.
Display shows E4 or E5 Temperature sensor of the
IGBT failure (open circuit/
short circuit)
Replace the power board.
ENGLISH ENGLISH
22 23