Page 12
10. Technical Information
SAT 5 MKII Specifications
Sealed Enclosure
Solid .75” MDF with 1” front / rear baffle and internal bracing
M6 X 12 inserts for attachment of Omnimount type 30 brackets
Dimensions (H x W x L):
10.88” x 6.62” x 11.43”
(includes heatsink and tweeter wave guide)*
*
For complete dimensions see page 14 [SAT 5 MK II Cabinet Dimensions].
Weight: 24 lbs.
.75” Tweeter
Dual concentric diaphragm with integral wave-guide
High-power ferrite motor structure
Full video shielded
5.25” Hemispherical Woofer
5.25 high excursion woofer with vented motor
Cast aluminum frame
1.5” Aluminum voice coil
Aluminum alloy cone with rubber surround
Copper shorting ring for lower distortion
Ultra low power compression design
Fully video shielded
Amplifiers & Electronics
60-Watts* into 4-Ohm (5.25” woofer)
.01% THD + noise at rated power @ 1 kHz
60 -Watts* into 4-Ohm (Tweeter)
.01% THD + noise at rated power @ 1 kHz
*
Power is limited by protection circuitry.
XLR electronically balanced input
Fixed and Adjustable gain controls
B00® optimized crossover
80Hz High Pass filter switch
Input impedance:
40K balanced
Common Mode Rejection
40dB typical @ 60Hz
Voltage Sensitivity (high gain) 200mv=90dB SPL @ 1 meter
Maximum Input Level:
+24dBu balanced
Frequency Response: +/- 3dB 80Hz to 30kHz
+/-1.5dB 200Hz to 15kHz
Low Frequency Cutoff
-3dB @ 80Hz
Internal High Pass Filter
80Hz 2nd order (selectable)
Internal Crossover Points
1.8kHz
