Blue Sky Network
May
2007
Page
26
D1000C IRIDIUM SATCOM DATA SOLUTION
100236
D1000C Power Cable
If the power harness between the circuit breaker and the D1000C Modem Unit is less than 10’,
there is no need to connect two PWR wires and two GND wires to the D-Sub connector (the
diagram below shows the case scenario for a long wiring scheme – above 10’). The D1000C
should work without problems if the installer chooses to only connect GND to pin 1 and PWR to
pin 2. Installation of a 3A circuit breaker is also highly recommended for protection purposes.
UNCONTROLLED COPY IF PRINTED