9
Owner’s manual and assembly instructions: model 223600 outdoor patio heater 1/15/03
Contact 1-800-762-1142 for assistance.
Do not return to place of purchase.
Step 6 – Attach Engine/Post to Platform
• Insert end of Post without holes over Gas Line, being careful not to
bend Gas Line.
• Slide Post into collar of Platform so Post rests completely on
Platform.
• Tighten bottom three setscrews with hex (Allen) wrench supplied.
• Make sure Post is perpendicular to Base.
• Use top three setscrews to adjust Post’s angle as necessary.
• Tighten all six setscrews.
Note:
Post must be perpendicular to Base. Failure to do so will
adversely affect burner performance.
Step 7 – Connect Gas Line to Engine
• Attach Gas Line to Control Valve:
• Pull collar of Gas Line back.
• Insert Gas Line over Control Valve.
• Release collar and it should lock in place. (Tip – push Gas Line up from
bottom of Post to make a good seating before releasing the collar.)
• Gently tug on line to test for proper connection. If Gas Line moves
you are not properly connected. Do not proceed until you have a
proper connection.
• Fully tighten the (4) screws from Step 5.
