Patriot
®
Braking System
405-0260 Rev A
Page 10 of 12 2/14/14
Breakaway Installation
The Breakaway system automatically activates the Patriot
®
to apply the brakes on your towed vehicle in the
event the motor home separates from the towed vehicle. This type of emergency system is required by most
states and provinces.
Mounting the Breakaway Switch
1. With the pin facing the motor home, secure the breakaway switch onto the front of the towed vehicle in a sturdy
location. This should be a convenient location which can be easily reached, and if possible, on the driver side.
Note: The breakaway switch must be mounted directly on the towed vehicle and not to be installed on the tow
bar or bracket. The surface must be strong enough to hold the breakaway switch and allow for the pin to be
pulled out cleanly.
2. Make certain that the switch is securely attached, and that the pin can be removed from the switch without any
interference. Plug the cable into the breakaway switch.
3. Install the breakaway switch using a bolt and lock nut. Do not use a self tapping screw.
Connecting the Breakaway Switch to the Patriot
®
Brake
There are two different ways to attach the break-away device to the Patriot
®
Brake. Use the method which is most
convenient for you.
Method 1: Through the firewall
1. Look for a pre-existing hole in the firewall, if no hole exists, drill a ½” diameter hole. Insert a grommet into hole.
Note: Make sure not to damage any components on either side of the firewall while drilling.
2. Find a path for the cable through the engine compartment to the firewall. Use wire ties to secure the cable.
Make sure to avoid any hot or moving engine parts.
3. Insert the cable into the grommet and pull the excess slack into the driver’s compartment. Seal around and
inside of the grommet with silicone sealant.
4. Plug the cable into the Patriot
®
Brake.
Note: When not in use, the cable can be tucked away .
Method 2: Feeding the cable through the door/window
1. Find a path for the cable through the engine compartment to the rear of the hood/base of the windshield, on the
driver’s side. Use nylon ties to secure the cable so that it is avoiding any hot or moving engine parts.
2. Either roll down the window and thread the cable through, or open the door and thread the cable through. Make
sure excess slack is safely coiled inside the driver’s cockpit. Once the cable is through and connected, close the
door/window.
!
Be sure the breakaway cable is kept
clear of the tow bar, safety cables,
electrical cord or any moving parts.
WARNING
