Mounting the Break-Away Switch
1. With the pin facing the motor home, secure the break-
away switch onto the front of the towed vehicle in a sturdy
location. This should be a convenient location which can
be easily reached, and if possible, on the driver’s side.
Note: The break-away switch must be mounted directly on
the towed vehicle and not to be installed on the tow bar
or bracket. The surface must be strong enough to hold
the break-away switch and allow for the pin to be pulled
out cleanly.
2. Make certain that the switch is securely attached, and
that the pin can be removed from the switch without any
interference. Plug the cable into the break-away switch.
3. Install the Break-Away Switch using a bolt and lock nut.
Do not use a self tapping screw.
Connecting the Break-Away Switch
to the Patriot® Brake
There are two diff erent ways to attach the break-away
device to the Patriot® Brake. Use the method which is
most convenient for you.
Method 1: Through the fi rewall
1. Look for a preexisting hole in the fi rewall, if no hole exists,
drill a ½” diameter hole. Insert grommet into hole.
Note: Make sure not to damage any components on either
side of the fi rewall while drilling.
2.
Find a path for the cable through the engine
compartment to the fi rewall. Use wire ties to secure the
cable. Make sure to avoid any hot or moving engine
parts.
3. Insert the cable into the grommet and pull the excess
slack into the driver’s compartment. Seal around and
inside of the grommet with silicone sealant.
4. Plug the cable into the Patriot® Brake.
Note: When not in use, the cable can be tucked away .
Method 2: Feeding the cable through the door/window
1)
Find a path for the cable through the engine
compartment to the rear of the hood/base of the
windshield, on the driver’s side. Use nylon ties to secure
the cable so that it is avoiding any hot or moving engine
parts.
2) Either roll down the window and thread the cable
through, or open the door and thread the cable through.
Make sure excess slack is safely coiled inside the driver’s
cockpit. Once the cable is through and connected, close
the door/window.
Installation
Th
is section will explain how to install the Breakaway.
Breakaway System
Description of your product.
Th
e Breakaway system automatically activates the Patriot® to apply the brakes on your towed vehicle in the event
the motorhome separates from the towed vehicle. Th
is type of emergency system is required by most states and
provinces.
Page 12 of 16
405-0084 Rev. B
7/8/10
