BX2198
2006-10 Ford Explorer/Mercury Mountaineer
2007-10 Ford Explorer Sport Trac
Installation Instructions
292-2993 Rev. E
Page 7 of 9
10/19/09
14. Align the metal bumper as close to it’s original position as possible, mark area to be cut on
the top and bottom of the side bumper. The top portion is to be removed, mark 5/8” wide
and approximately 2-1/2” toward the weld on the front edge of the bumper on both sides, to
alleviate the area for the upper baseplate end plate. Mark the lower portion to be removed 1”
wide and approximately 1-1/4” toward the front of bumper on both sides (to alleviate the area
for front lower baseplate bolt head).
14-A
15-A
15. Secure the metal bumper to a work bench with the vise grips and cut designated areas from
the previous step with the reciprocating saw. After cutting, clamp vise grip to the cut portion
to be removed and move vise grip back and forth until cut portion breaks. Reinstall metal
bumper to verify enough of metal bumper is removed. Trim as needed and reinstall bumper
with existing hardware.
15-B
14-B
