Installation
PRODUCT ASSEMBLY
•
Leaf Eater Commercial Rain Head
•
Tape measure
•
Marker pen
•
Saw
•
Bracket
•
Screws
•
Screwdriver or drill
WHAT’S IN THE BOX?
WHAT’S IN THE BOX?
TOOLS/MATERIALS YOU MAY REQUIRE
Distance from wall
30mm
Pipe cut angle 30°
Fastening points x4
Distance from wall
30mm
Distance between pipe
and screen 50mm
1.
Locate the position at which you will be installing your Leaf Eater Commercial rain head.
Whether this is directly under your eave or midway down your downpipe, it should be a
minimum of 500mm above your tank inlet and tank overflow pipe.
2. Cut and bracket your bottom downpipe to the wall, being sure to offset it 30mm from the
wall.
3. Insert your Leaf Eater Commercial rain head into the pipe and mark the side flange fastening
holes. Remove your rain head and prepare the necessary fastening points. Then reinsert your
rain head and fasten it to the wall, ensuring it’s adequately supported by the wall structure.
4. Cut your upper downpipe at an angle of 30 degrees to match the angle of your rain head’s
stainless steel screen. Cut the pipe 50mm above the rain head screen and install it with
a 30mm offset from the wall.
GUTTER, EAVE & “MID” MOUNT
MAINTENANCE
Your rain head’s Clean Shield™ screen is mostly self-cleaning. However, it is prudent to
periodically inspect it to check if cleaning is necessary.
