Installation
WHAT’S IN THE BOX?
•
Grey Water Diverter
•
Marker pen
•
Measuring tape
•
Saw
•
Solvent weld glue
•
Priming fluid
WHAT’S IN THE BOX?
TOOLS/MATERIALS YOU MAY REQUIRE
GREY WATER DIVERTER
1.
Select your desired installation point. The Grey Water Diverter can be installed for non-
pressurised rainwater, stormwater and grey water applications on vertical and horizontal
pipes.
2.
To install, measure and remove a 136mm section of pipe (for 90mm models) or 87mm section
of pipe (for 50mm models) at your desired installation point. Ensure all cut edges are clean
and smooth.
3.
Use priming fluid to clean inside all sockets of the Grey Water Diverter and the outside of the
pipes you will be gluing too.
4.
Apply solvent weld glue first to inside of the two sockets on your Grey Water Diverter that
will attach the the existing pipe work and then to the outside of the pipes. Bring together and
ensure the pipes are inserted fully into the sockets of the Grey Water Diverter.
5.
Apply sovent weld glue to the remainder socket and outside of the new pipe you will be
diverting water to. Insert the pipe and hold until secure ensuring pipe has been inserted fully.
6.
Your Grey Water Diverter is designed to switch the direction of flow through your pipes. This
is done by rotating the flow control handle. The “X” on the handle indicates the sealed pipe.
Importantly, the handle can only be rotated 90 degrees between two pipes and the “X” should
never point up. As such, it may be necessary to adjust the handle orientation to suit your
installation.
7.
To adjust the flow control handle orientation, unscrew the front locking ring and pull the
handle fully out of the unit. Reinsert the handle so it’s oriented to suit your installation and will
fully close one pipe direction. If necessary, press the O-ring back in around the handle, then
screw the front locking ring back on to secure the handle in place. Twist the handle to test
everything is working as it should.
ALL DIMENSIONS IN MM UNLESS OTHERWISE STATED.
Pipe Fitment
HW0002
DN50 F (socket)
50mm pipe fits inside
HW0001
DN90 F (socket)
90mm pipe fits inside
DISCLAIMER This product specification is not a complete guide to product usage. Product specifications may change
without notice. For more information visit rainharvesting.com.au. Keep this manual handy for future reference. © Rain
Harvesting Pty Ltd.
COMPLIANCE
•
Australian Standard AS/NZS 4020:2005 (Testing of products for use in contact with drinking water)
PRODUCT DIMENSIONS
HW0002 – 50mm
SIDE VIEW
FRONT VIEW
HW0001 – 90mm
SIDE VIEW
NOTE: The use of grey water is regulated by state/territory or local government environmental
health and/or water authorities. Before use, please ensure installation complies with all state/
territory and local government guidelines.
112
DN50F
DN50F
DN5
0F
101
14
8
164
DN90 F
DN90 F
DN90 F
FRONT VIEW
125
197
