Blue Mark DroneBeacon 100 Series, Manual, Page: 6 / 11

DroneBeacon Transponder Manual - version 1.2 July 2022 - © BlueMark Innovations BV 2022
6/11

Suited for outdoor operation:

IP43 rating

for operation in rainy conditions, the transponder needs to be protected against water.

Suited for medium and larger drones. “
DJI Mavic
” is the minimum size.

Size: 99 x 66.5 x 41 mm

without screw noses and antenna: 81 x 66.5 x 10 mm

Operating temperature

-5°C to +40°C

Weight: 56 g
Figure 1 - DroneBeacon 100-serie transponder
1.3 Charging
The transponder can be charged using a standard USB-C charger. It is fully charged after 2 hours.
During charging, the charging LED will be
red . If fully charged, this LED will turn to blue .
1.4 Installation
Attach the DroneBeacon transponder to your drone. For optimal coverage install the transponder
horizontally with the antenna facing up
3
. The detection range will be severely limited when it is
installed under an angle of 15 degrees or more.
semi-permanent/temporarily installation
Use the (included) 3M dual-lock stickers (type 3M SJ4570). One sticker on the bottom of the
transponder and the other on the drone where you want to install the transponder. If you attach the
transponder on the bottom of the drone (
upside down
), use M5-screws!
Note: for a good adhesion/grip, place the dual-lock sticker and apply firm consistent pressure to
assure good contact with the substrate you are adhering. Also, it needs 1 hour to 72 hours
(preferred) to build a (full) adhesion to the surface. In addition, it is important that the adhesive base
for the tape is free of grease and dry, and that it is not covered with a removable lacquer or a layer
of paper.
permanent installation
The transponder can be attached to the drone using two M5 screws.
3 For high flying drones > 75 m, install the transponder facing down, on the bottom of the drone for maximum
range. The antenna pattern is similar to a
dipole antenna
, radiating remote ID signals in a donut-shape.