MOUNTING INSTRUCTIONS
MOUNTING S-HOOKS AND PEGS/
CARE AND MAINTENANCE/
From time to time, check all hardware to make certain it is still fully tightened.
1
2
3
4
5
MOUNTING RAILS SEPARATELY
1.Locate wall studs with a stud finder and mark the locations with a pencil.
To gain more space, alternate tool handles, one tool handle end up, one tool handle end down.
4.S-hooks: Slide hook (C) through hole in slot until hook protrudes from other end of slot.
5.Press peg (D) into keyhole slot. Be sure peg is in all the way. To remove, pull peg straight out.
2.Place the rail (A) at desired height aligning it with the studs. Place the side with 2 screw holes
to the left. Loosely mount the left end of the rail with one screw (AA). Level the rail (A), cover
the opposite end with end cap (B) and screw (AA) this end in fully. Go back and fully tighten
first screw (AA) and insert 2 remaining screws (AA), making sure all screws (AA) are fully
tightened. Use anchor with any screws (AA) that do not hit a stud.
3.Place the rail (A) at desired height, aligning it with the studs. Place the side with 2 screw holes to
the left. Loosely mount the left end of the rail with one screw (AA). Level the rail (A), cover the
opposite end with the left side of the next rail in the line and screw (AA) this end in fully. Repeat
this procedure until desired rail length is obtained. Cover end of last rail (A) with end cap (B) and
screw it in. Use anchor (BB) with any screws (AA) that do not hit a stud.
