BLUE CHIP AIX-101, Owner'S Manual, Page: 6 / 15

6
Installation
■
Hardware
The following parts are provided for installation
of the controller unit. Please make sure you have
all the parts.
• Self-tapping round-head screw (3x16mm)
.................................. 1
• Double-sided adhesive tape .................................. 3
• Re-usable double-sided adhesive pads
(transparent). ............ 3
• Spacer (double-sided adhesive). ........................... 6
• Velcro fastener ....................................................... 1
• Bracket .................................................................... 1
• Suction cups ........................................................... 3
■
Installation Procedure
1. Determine the optimum
location for installation.
Normally, the controller should be attached
somewhere behind the guitar’s bridge, as shown in
the illustration. It should be accessible, but it
should not interfere with your playing or any of the
guitars controls or adjustments. Consider the
following points carefully when deciding on the
best location to install the controller:
• The controller should not get in the way of your
picking-hand at any time. Make sure the location
you choose will not affect your playing style.
• The controller should not block or hamper
access to any of the guitar’s controls: tone,
volume, bridge adjustments (especially watch
out for intonation/saddle screws accessed from
the rear of the bridge).
• The controller must be well within reach of both
the pickup cable (when the pickup is in its final
installed position) and the direct guitar cable
• Neither the controller unit itself nor any of the
connected cable plugs should extend beyond the
body of the guitar to prevent accidental dam-
age.
Controller
Pickup
Direct guitar’s cable
Multi-pin cable (13 pin cable)
GUIT
A
R
MIX SYNTH
UP
DO
WN
VO
L
OUT
AC
12 V
1,5 A
INDUSTRIESTRASSE 1
56283 HALSENBACH
GERMANY
MIDI