28mm Walkway
–
Stairs
B28-SF-229
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in
place while you allow glue to dry.
Take the two pieces shown above from the sprue.
Glue the one on the left to the
back
of the one on
the right.
Take the barricade sections
…
..and glue them into position (see pic).
Take the rear barricade piece.
Glue it into position as shown above. Leave this
assembly to dry.
Take the two rear support pieces
Glue the one on the left to the
back
of the one on
the right. Allow to dry.
