28mm Walkway
–
Firing Point
B28-SF-226
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in
place while you allow glue to dry.
Take the two pieces shown above from the sprue.
Glue the one on the right to the
back
of the one on
the left.
Take the lower barricade section
…
..and glue it into position (see pic).
Take the upper barricade section
…
..and attach that to the model as shown.
The rear barricade section.
Glue this into place. Leave this
“
front
”
assembly to
dry.
