The two side walls
…
.. are then glued into position
–
high edge towards
the front of the privy..
The door, upper support and rear piece.
Place the upper support on top of the door, then
insert the lower peg of the door into the hole in the
base. Gently slide the upper support into the gap
provided (see pic).
The upper support should end up flush with thje front
of the privy as shown above.
Glue the rear piece to the back of the front wall, so
it helps to hold the upper support in place.
The roof and door frame.
Glue these into place. The roof should extend out
more forwards than backwards.
The completed privy.
