10mm 3x2 Residential Roof
B10-MW-200
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Roof Section (B10-MW-200)
Remove the four walls and roof from the sprue.
Apply glue to the edges of the roof and attach
the walls to it using the lugs provided (etched
detail outwards).
Glue the balconies into position below the
windows.
Now remove the four rectangles from the sprue.
Each of these has a line etched across it. Apply glue to
one side of the line only and attach it (as shown in the
example above) to the centre
bottom
edge of each
wall.