BLOTZ B10-MW-114 Instructions Download Page 1

10mm Monorail Station  

(Single Platform) 

B10-MW-114 

 

Please read these instructions fully before starting construction. 

PVA or equivalent glue will be required to stick sections together. 

Sand paper can be used to gently clean any joints. 

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due 

care and remember to cut away from yourself at all times. 

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold 

pieces in place while you allow glue to dry. 

 

 

Start  by  removing  the  support  pillar  pieces  from 
the sprue. The image shown above is for a single 
support pillar. 
 

 

Glue  the  pieces  together  as  shown  above,  with  the 
slots  being opposite  each other.  Repeat  for the  other 
pillar. 

 

Glue the lugs at the bottom of each pillar into its 
base. Allow glue to dry.  

 
 

 

Now take the platform piece and the seven stanchions 

from the sprue. 

 

Turn the platform piece upside down and glue 

the stanchions in place as shown. Allow to dry. 

 

Each of the roof supports is formed from four pieces 

(shown above). Glue them together as shown with the 

slots opposite each other. Allow to dry. 

Reviews: