6mm 3x2 Shops Middle
B06-MW-150
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Mid-Section (B06-MW-150)
Remove the walls, two bracer bars and four
supports from the sprue. Glue the bracers to the
back
of the two short walls as shown in the
example above. Also attach the support to the
bottom edge on the
back
of each wall. Leave to
dry.
Once the bracers are dry, apply a little glue to the side
lugs and glue the shorter walls in place. You should
now have a hollow square structure. Leave it to dry.
Note: In the image above, the structure is upside
down, so the supports are seen at the top of the
picture.
Glue the balconies into position on the long
walls…
…and then on the short walls.
