ADR | Oberer Buxheimer Weg 60, D-87700 Memmingen P | +49 8331-756 965 80 E | [email protected]
blossom-ic GmbH & Co. KG | Intelligent Controls
8
Attention! Important note:
Installation and assembly of electrical devices may only be carried out by a qualified electrician. Non-observance of the assembly and instal-
lation instructions may result in fire or other hazards.
Safety Instructions
The fits valves with an M 30 x 1.5mm connection. Suitable makes: Heimeier, Junkers, Landys & Gyr, MNG, Honeywell 30 x 1.5, Herz 30
x 1.5 and Oventrop 30 x 1.5..
Adapter:
To mount the on Danfoss valves you need an adapter (e.g. from Heimeier):
Heimeier 9700-24.700 (Adapter for Danfoss RAV/L valves)
Heimeier 9702-24.700 (Adapter for Danfoss RA valves)
Heimeier 9800-24.700 (Adapter for Danfoss RAV valves)
For niches we recommend our product Avalon Combo+.
For all other valves, please use the different adapters of the respective manufacturers. These are available from specialist dealers on request.
We recommend metal adapters for exact functionality!
Mounting on the valve
Further information
Hint:
When the batteries are empty and the ther-
mostat switches off, the heating in the last
activated mode, to switch the Freezing of the
heating and the unwanted to prevent cool-
ing of the rooms is the Frost protection (6°C)
activated.
What is to be done?
To restore normal operation please change
the batteries immediately. The system has
a memory function that automatically re-
stores the last set heating program.
Valve protection function:
The system opens and closes the valves once
a week automatically, so that ensures that
the valves do not/or block it.
Hereby blossom-ic GmbH & Co. KG hereby declares that the following product: AP-3977 is in compliance with the essential require-
ments and other relevant provisions of Directive 2014/53/EU. The complete declaration of conformity can be found at the following address:
www.blossomic.de/downloads Declaration of conformity
Declaration of conformity
Reset thermostat to factory setting
Press comfort button until “bin” appears in the display -> press comfort button until “Set” ID appears. -> Select ID 0 and confirm with “Com-
fort-Key”
