bloom fresco, User Manual

Page: 29 / 93

eng
9
Behind the nest pad, slide the buckle on the
end of the shoulder straps into the buckle slots
located on the inner face of seat unit. (refer to
illustration d1)
– Thread the crotch strap through upper
opening to the lower opening of the comfort
nest. When removing the crotch strap from
comfort nest, beware of the loose end of the
strap to stick under the comfort nest. (refer to
illustration d2)
– Behind the seat pad, pull open storage
compartment door located on the inner face
of seat unit. Slide the buckle on the end of the
waist straps into the buckle slots on either side
of the storage compartment. Check the straps
are secured by pulling on the straps. (refer to
illustration d4)
– Close the compartment door.
– (Without safety bar) put the loose end of the
crotch strap under the crotch strap cover,
and then into the buckle slots of the seat unit.
Check the straps are secured by pulling on the
straps. (refer to illustration d3)
– (With safety bar) Insert the loop on the end of
the crotch strap through the upper hole of the
crotch strap cover, and then put the loose end
under the base of the crotch bar. Then slide
the base of the crotch bar into the seat unit.
The strap and buckle must not be twisted or
inverted. This will ensure correct locking of the
harness. (refer to illustration d5)
– Place the comfort nest into the seat unit, and
then press in towards the backrest.
– Check the straps are secured by pulling on the
straps.
– Adjust the length of the harness straps until it
fits snugly around your child.
WARNING:
– Always use the safety harness.
– The comfort nest must be used in
conjunction with the mini tray
Section E: Toddler Chair Mode
– suitable for 36 months to 36kg /
79lbs (refer to illustrations section e)
Seat Pad Assembly
– (#12 storage compartment) Behind the seat
pad, pull open storage compartment door
located on the inner face of seat unit.
– (#13 Bar attachment caps, #14 crotch cover)
From storage compartment, take out the two
bar attachment caps and the crotch strap
cover. Close the compartment door.
– (#07 seat pad) Place seat pad onto the seat
unit; secure onto velcro. (refer to illustration e1)
– Snap the Bar attachment caps on either side
of the seat unit; you will hear an audible click.
– Slide the crotch strap cover into the seat unit.
(refer to illustration e2)
Seat Unit Height
To adjust seat height, disengage the swivel/
height resistor. Lift both A & B trigger
simultaneously, whilst pushing downwards or
pulling upwards to desired height, then release
the triggers. (refer to illustration e3)