24 HDE-8C DIN Series
Instruction Manual
6.6 “Main > Output” Screen
The “Main > Output” section includes the following sub- tabs: TS Config, QAM, IP (QAM/IP Model Only) and Refresh.
In the section entitled “
Multiplexed MPTS Output Configuration
”, the user can select and configure the following
parameters of the MPTS output stream:
TS ID:
user must enter the identification number for the output TS. The range is 1 to 65535. The TS ID assigned must
be unique.
TS Bitrate:
user must select bitrate for the TS. Options are: “QAM Modulator”, “19.39 Mbps”, and “38.81 Mbps”.
Modulation Mode:
user can select the modulation mode. Options are: “Reserved”, “Analog”, “QAM64”, “QAM256”,
“8-VSB”, and “16-VSB”.
1
2
3
6.6.1 “Main > Output > TS Config” Screen
The “Main > Output > TS Config” screen (
) is a “user-configurable” screen where the following output parameters
are configured and displayed for each output stream:
Figure 6.6.1 - “Main > Output > TS Config” Screen
1
2
3
4
5
6
7
8
9
10
11
12
