Washing Machine /User’s Manual
33 / EN
Maintenance and cleaning
In order to clean the dirty filter and discharge the
water:
1. Unplug the machine to cut off the supply power.
A
WARNING:
Temperature of the water
inside the machine may rise up to 90 ºC.
To avoid burning risk, filter must be cleaned
after the water in the machine cools down.
2. Open the filter cap.
If the filter cap is composed of two pieces,
press the tab on the filter cap downwards and
pull the piece out towards yourself.
If the filter cap is one piece, pull the cap from both
sides at the top to open.
C
You can remove the filter cover by slightly
pushing downwards with a thin plastic
tipped tool, through the gap above the filter
cover. Do not use metal tipped tools to
remove the cover.
3. Some of our products have emergency draining
hose and some does not have. Follow the steps
below to discharge the water.
Discharging the water when the product has an
emergency draining hose:
a. Pull the emergency draining hose out from its
seat
b. Place a large container at the end of the hose.
Drain the water into the container by pulling
out the plug at the end of the hose. When the
container is full, block the inlet of the hose
by replacing the plug. After the container is
emptied, repeat the above procedure to drain
the water in the machine completely.
c. When draining of water is finished, close the
end by the plug again and fix the hose in its
place.
d. Turn the pump filter to take it out.
4. Clean any residues inside the filter as well as
fibers, if any, around the pump impeller region.
5. Install the filter.
6. If the filter cap is composed of two pieces, close
the filter cap by pressing on the tab. If it is one
piece, seat the tabs in the lower part into their
places first, and then press the upper part to
close.
