Blomberg WM 67121 NBL00, Owner'S Manual

Page: 25 / 40

25
EN
6 Quick instructions for daily use
Preparation
1. Turn on both hot and cold water
faucets fully. Check and be sure the
water connection is tight.
2. Place the laundry in the drum.
3. Add laundry additives (e.g. detergent,
fabric softener,bleach).
Starting
1. Press the “On/Off” button.
2. Select the appropriate wash cycle
and temperature suitable for your
items.
3. If required:
– select any auxiliary function,
– adjust the spin speed,
– set the time delay,
4. Close the loading door.
5. Press “Start/Pause/Cancel” button.
The display shows the time remaining
for the program to complete if time
delay is not set.
6. Check if the program follow-up
indicator on the screen lights up.
Canceling a program
1. Press and hold the `Start/Pause/
Cancel` button for about 3 seconds;
the “Ready” light will start flashing.
2. The machine can drain all the water
or can take in water for 3 times at
most to cool down the clothes and
complete draining process.
Adding more laundry
• This is only possible under the
following conditions:
1. during time delay,
C
You may add or remove laundry
during the time delay (until the
program starts).
2. At the beginning of a washing cycle,
C
Machine allows adding more laundry
during a future step only if the water
level is low enough to open the
loading door or if the temperature in
the machine is low
In order to add laundry after the start-up
of the program:
1. Press “Start/Pause/Cancel”
button. Wait for the safety lock to
open. “Ready” lamp will light up
continuously.
2. Open the loading door and put in
more laundry.
3. Close the loading door.
4. Press “Start/Pause/Cancel” button.
Re-spinning the laundry
The control system for an unbalanced
load can pause the spinning in cases
when the distribution of the laundry in
the drum is not balanced.
If you want to re-spin the clothes:
1. Rearrange the previously placed
clothes in the drum.
2. Select the spin program.
3. Adjust the spin speed.
After the program is finished
Program indicator lights on the screen
remain lighted up after the program is
finished.
1. “End” will appear on the screen when
“ready” lamp lights up in the program
follow-up indicator. Open the loading
door and remove the laundry.
2. Press the “On/Off” button.
3. Turn off the faucets.
4. Check the rubber door seal for any
foreign objects.
5. Leave the door and dispenser drawer
open to dry.