18
water inlet models, 2 for single water
inlet models) on hose or plastic bag
for eliminating any leakage in con-
nections points. These seals must be
used on each side of the connection.
Seals on machine side must be con-
nected filter cannal.
After connecting the hose, check
all connections for leaks In order to
eliminate any risk due to water leak-
age keep the taps off when machine
is not used.
Your machine will operate efficiently if
the water from tap is minimum 1 and
maximum 10 bars. Practically 1 bar
means 8 liters of water in one minute
when tap is fully on.
Connect hose to the machine.
Tighten bolts with hand power, do not
use spanner.
Double inlet models can be used with
blind cap as a single inlet machine.
Connect blind cap to hot water inlet.
Seal must be for stopping water leak-
age.
Do not connect single inlet machine
to hot water. If machine is connected
with Y part to a double inlet and over
40˚C for single inlet machines, ma-
chine may switch to protection mode.
b) Water drain hose
Water drain hose could be placed
either at the side of the bath tub, or
directly to the drain. The hose should
not be bent. Water drain hose should
be secured with the holder so that it
would not fall down on the ground.
The hose should be placed between
40 and 100 cm. from the ground.
Water drain hose could be placed
directly to the drain water inlet.
4. Electrical connection
Connect the power cord to the ap-
propirate electrical system which is
being supported by the maximum
voltage and current rating indicated
on the rating plate placed inside the
kick plate.
Look! Page 1, Steps before operating
Fullautomatic Washing Machine and
safety precautions.
Make sure that you have grounded
power outlet.
Attention! Before any operation of the
machine check the following.
• Did you close the front door?
• Is the tap open?
• Is water drain hose placed properly?
• Is power connected?
