Blomberg SND 9680, Operating Instructions Manual

Page: 8 / 54

EN
7
3 Installation
B
Please remember that the manufacturer
shall not be held liable if the information
given in the instruction manual is not
observed.
Points to be considered
when re-transporting your
refrigerator
1.
Your refrigerator must be emptied and
cleaned prior to any transportation.
2.
Shelves, accessories, crisper and etc.
in your refrigerator must be fastened
securely by adhesive tape against any jolt
before repackaging.
3.
Packaging must be tied with thick tapes
and strong ropes and the rules of
transportation printed on the package
must be followed.
Please do not forget…
Every recycled material is an indispensable
source for the nature and for our national
resources.
If you wish to contribute to recycling the
packaging materials, you can get further
information from the environmental
bodies or local authorities.
Before operating your
refrigerator
Before starting to use your refrigerator check
the following:
1.
Is the interior of the refrigerator dry and can
the air circulate freely in the rear of it?
2.
Please install the 2 plastic wedges as
illustrated in the figure. Plastic wedges will
provide the required distance between
your refrigerator and the wall in order to
allow the air circulation. (The illustrated
figure is only an example and does not
match exactly with your product.)
3.
Clean the interior of the refrigerator as
recommended in the “Maintenance and
cleaning” section.
4.
You will hear a noise as the compressor
starts up. The liquid and gases sealed
within the refrigeration system may also
give rise to noise, even if the compressor
is not running and this is quite normal.
5.
Front edges of the refrigerator may feel
warm. This is normal. These areas
are designed to be warm to avoid
condensation
Electric connection
Connect your product to a grounded
socket which is being protected by a fuse
with the appropriate capacity.
Important:
• The connection must be in compliance with
national regulations.
• The power cable plug must be easily
accessible after installation.
• The specified voltage must be equal to your
mains voltage.
• Extension cables and multiway plugs must
not be used for connection.
B
A damaged power cable must be
replaced by a qualified electrician.
B
Product must not be operated before it
is repaired! There is danger of electric
shock!