Blomberg LWI842, User Manual

Page: 11 / 52

Washing Machine /User’s Manual
11 / EN
3 Installation
Refer to the nearest Authorised Service Agent for
installation of the product. To make the product
ready for use, review the information in the user
manual and make sure that the electricity, tap
water supply and water drainage systems are
appropriate before calling the Authorised Service
Agent. If they are not, call a qualified technician
and plumber to have any necessary arrangements
carried out.
C
Preparation of the location and electrical, tap
water and waste water installations at the place of
installation is under customer's responsibility.
Make sure that the water inlet and discharge
hoses as well as the power cable are not folded,
pinched or crushed while pushing the product into
its place after installation or cleaning procedures.
B
WARNING:
Manufacturer shall not be held
liable for damages that may arise from procedures
carried out by unauthorised persons.
A
WARNING:
Prior to installation, visually check
if the product has any defects on it. If so, do not
have it installed. Damaged products cause risks
for your safety.
3.1 Appropriate installation location
• Place the machine on a rigid floor. Do not place
it on a long pile rug or similar surfaces.
• Total weight of the washing machine and the
dryer -with full load- when they are placed
on top of each other reaches to approx. 180
kilograms. Place the product on a solid and flat
floor that has sufficient load carrying capacity!
• Do not place the product on the power cable.
• Do not install the product at places where
temperature may fall below 0ºC.
• Place the product at least 1 cm away from the
edges of other furniture.
3.2 Removing packaging
reinforcement
Tilt the machine backwards to remove the
packaging reinforcement. Remove the packaging
reinforcement by pulling the ribbon.
3.3 Removing the
transportation locks
A
WARNING:
Do not remove the transportation
locks before taking out the packaging
reinforcement.
WARNING:
Remove the transportation safety
bolts before operating the washing machine!
Otherwise, the product will be damaged.
1. Loosen all the bolts with a suitable spanner until
they rotate freely (C) .
2. Remove transportation safety bolts by turning
them gently.
3. Attach the plastic covers supplied in the User
Manual bag into the holes on the rear panel. (P)