Blomberg LRI285411, User Manual, Page: 23 / 84

User’s Manual
23 / EN
Installation
Adjusting Rear Feet
• When you turn the knob (visible in the circle) in the direction of the arrow, the
machine will be elevated by 0.3 mm. When you turn it in the opposite direction of
the arrow, the machine will be lowered by 0.3 mm.
• Do not adjust the rear feet by using chargeable devices. Use a screwdriver instead.
3.7 Electrical connection
Connect the product to a grounded outlet protected by a 16 A fuse. Our company
shall not be liable for any damages that will arise when the product is used without
grounding in accordance with the local regulations.
• Connection must comply with national regulations.
• The wiring for the electrical outlet circuit must be sufficient to meet the appliance
requirements. Use of a Groud Fault Circuit Interrupter (GFCI) is recommended.
• Power cable plug must be within easy reach after installation.
• If the current value of the fuse or breaker in the house is less than 16 Amps, have a
qualified electrician install a 16 Amp fuse.
• The voltage specified in the "Technical specifications" section must be equal to
your mains voltage.
B DANGER!
Damaged power cables must be replaced by the
Authorised Service Agent.
Important
Fitting a different plug
As the colours of the wires in the mains lead of this appliance may not correspond
with the coloured markings identifying the terminals on your plug, proceed as
follows: