![background image](http://html1.mh-extra.com/html/blomberg/ldvn2284/ldvn2284_instruction-manual_2773952011.webp)
Dishwasher / Instruction Manual
11 / 39
EN
Installation
terminal in the plug marked ‘L’ or
coloured red.
With the alternative plugs a 13A fuse must
be fitted either in the plug or adaptor or
in the main fuse box. If in doubt contact a
qualified electrician.
Initial use
Before starting to use the product, make
sure that all preparations are made in
accordance with the instructions in
sections “Important safety instructions”
and “Installation”.
•
Before using the product, fill the salt
reservoir with 1 litre of water, add salt
(see next page) and stir to dissolve.
Run the Dishwasher without dishes
on a short programme with a small
amount of detergent.
A
There might be a small amount
of water left in the product
after factory quality control
tests. This causes no harm to
the product.
A
This appliance must
be earthed
If the fitted moulded plug is not
suitable for your socket, then
the plug should be cut off and
an appropriate plug fitted.
Destroy the old plug, which is
cut off as a plug with a bared
cord could cause a shock
hazard if inserted into a socket
elsewhere in the house.
The moulded plug on this
appliance incorporates a 13A
fuse. Should the fuse need to
be replaced an ASTA approved
BS1362 fuse of the same rating
must be used. Do not forget
to refit the fuse cover. In the
event of losing the fuse cover,
the plug must not be used
until a replacement fuse cover
has been fitted. Colour of the
replacement fuse cover must
be the same colour as that
visible on the pin face of the
plug. Fuse covers are available
from any good electrical store.
Fitting a different plug
As the colours of the wires in the mains
lead of this appliance may not correspond
with the coloured markings identifying the
terminals on your plug, proceed as follows:
1. Connect the green - yellow or green
(earth) wire to the terminal in the plug
marked ‘E’ or with the symbol
or
coloured green and yellow or green.
2. Connect the blue (neutral) wire to
the terminal in the plug marked ‘N’ or
coloured black.
3. Connect the brown (live) wire to the