Dishwasher / User manual
11 / 40
EN
Installation
2. Connect the blue (neutral) wire to
the terminal in the plug marked ‘N’ or
coloured black.
3. Connect the brown (live) wire to the
terminal in the plug marked ‘L’ or
coloured red.
With the alternative plugs a 13A fuse must
be fitted either in the plug or adaptor or
in the main fuse box. If in doubt contact a
qualified electrician.
Initial use
Before starting to use the product, make
sure that all preparations are made
in accordance with the instructions in
sections “Important safety instructions”
and “Installation”.
•
Before using the product, fill the salt
reservoir with 1 litre of water, add salt
(see next page) and stir to dissolve.
Run the Dishwasher without dishes
on a short programme with a small
amount of detergent.
A
There might be a small
amount of water left in the
product after factory quality
control tests. This causes no
harm to the product.
A
This appliance must
be earthed
If the fitted moulded plug is
not suitable for your socket,
then the plug should be cut
off and an appropriate plug
fitted.
Destroy the old plug, which
is cut off as a plug with a
bared cord could cause a
shock hazard if inserted into
a socket elsewhere in the
house.
The moulded plug on this
appliance incorporates a
13A fuse. Should the fuse
need to be replaced an
ASTA approved BS1362
fuse of the same rating must
be used. Do not forget to
refit the fuse cover. In the
event of losing the fuse
cover, the plug must not be
used until a replacement
fuse cover has been fitted.
Colour of the replacement
fuse cover must be the
same colour as that visible
on the pin face of the plug.
Fuse covers are available
from any good electrical
store.
Fitting a different plug
As the colours of the wires in the
mains lead of this appliance may not
correspond with the coloured markings
identifying the terminals on your plug,
proceed as follows:
1. Connect the green - yellow or
green (earth) wire to the terminal
in the plug marked ‘E’ or with the
symbol
or coloured green
and yellow or green.