9 / 34 EN
Refrigerator / User Manual
3
Installation
Always have the repair procedures carried
out by the Authorised Service Agent.
Manufacturer shall not be held liable for
damages that may arise from procedures
carried out by unauthorised persons.
To make the product ready for use, make
sure that the electricity installation is
appropriate before calling the Authorised
Service Agent. If not, call a qualified
electrician to have any necessary
arrangements carried out.
C
Preparation of the location and
electrical installation at the place
of installation is under customer's
responsibility.
B
Product must not be plugged
in during installation. Otherwise,
there is the risk of death or
serious injury!
B
WARNING:
Manufacturer shall
not be held liable for damages
that may arise from procedures
carried out by unauthorised
persons.
A
WARNING:
Prior to installation,
visually check if the product
has any defects on it. If so, do
not have it installed. Damaged
products cause risks for your
safety.
C
Make sure that the power cable
is not pinched or crushed while
pushing the product into its
place after installation or cleaning
procedures.
3.1. Appropriate
installation location
A
WARNING:
If the door of the
room where the product will be
placed is too small for the product
to pass, then the product's doors
can be removed and the product
turned aside to pass it through.
• Choose a place at where you would
use the product comfortably.
• Install the product at least 30 cm away
from heat sources such as hobs, ovens,
heater cores and stoves. Product must
not be subjected to direct sun light and
kept in humid places after installation.
• Appropriate air ventilation must be
provided around your product in order
to achieve an efficient operation. If the
product is to be placed in a recess in
the wall, pay attention to leave at least
5 cm distance with the ceiling and side
walls.
• Do not place the product on the
materials such as rugs or carpets.
• Place the product on an even floor
surface to prevent jolts.
• Do not install the product in places
where the temperature falls below -5°C.
C
If two coolers are to be installed
side by side, there should be at
least 4 cm distance between them.
3.2. Installing the
plastic wedges
Plastic wedges are used to create the
distance for the air circulation between
the product and the rear wall. Insert the
2 plastic wedges onto the rear ventilation
cover as illustrated in the figure. To install
the wedges, remove the screws on the
product and use the screws given in the
same pouch with the wedges.
