Blomberg DW51600FBI, Installation Manual, Page: 13 / 30

10
USA
6.3 ADJUSTING HEIGHT
If the height of the enclosure is 337/8” to 357/8”
(861 mm - 911mm) adjust supports as shown in
the figure.
Supplied ( 4 )
Adjust the front foot level with the adjusting
wrench to balance and raise the dishwasher to the
enclosure height.
Adjust the rear foot level with a screwdriver to
balance and raise the dishwasher to the enclosure
height.
NOTICE :
• Make sure the dishwasher is plumb and
notice dishwasher can be placed with a small
clearance under the counter top.
• Turning the screwdriver in the direction of the
black arrows will bring the dishwasher back feet
up.
• Turning the screwdriver in the direction of the
white arrows will take the dishwasher rear feet
down.
6.4 INSTALLING THE SIDE TRIM STRIPS
Remove the adhesive tape (Figure A ).
Place the trim strips on the front edge of the side
walls (Figure B ).
NOTICE :
• Make sure you use the correct trim strip since
there is a left and right side strip. The flexible
material should be facing forward (Figure B ).