23 - EN
7
Troubleshooting
Problem
Cause
Explanation / Solution
Drying process
takes too long.
Lint filter may not have been
cleaned.
* Clean the lint filter.
Dryer does not
switch on or the
program does
not start. Dryer
does not start
when set.
* It may not plugged in.
* The loading door may be ajar.
* Program may not be set or the
“Start/Pause/Cancel” button may
not have been pressed.
* “Childproof lock” may be
activated.
* The condenser cover on models
with a condenser may not be
closed securely.
* Make sure that the dryer is plugged
in.
* Make sure the loading door is
properly closed.
* Make sure the program has been set
and it is not in “Pause” mode.
* Deactivate the childproof lock.
* Make sure the condenser cover and
the red lock is closed securely.
Program is
interrupted for
no reason.
* The loading door may be ajar.
* Electricity may be cut off.
* Make sure the loading door is
properly closed.
* Press the “Start/Pause/Cancel”
button to start the program.
Laundry has
shrunk, become
felted or has
deteriorated.
* A program not suitable for the
laundry type might have been
used.
* Dry only the laundry which is suitable
for drying in the dryer. First check the
labels on the clothes.
* Select a program a suitable low
temperature setting for the laundry
type to dry the clothes.
Drum light does
not come on.
(for models
equipped with a
lamp)
* The dryer may not have been
started using the On/Off button.
* Bulb may have burned out.
* Make sure the dryer is On.
* Call the authorized service to replace
the bulb.
“End /
Anticrease” LED
flashes.
* The 2-hour anti creasing
program to prevent laundry
from wrinkling may have been
activated.
* Turn off the dryer and take the
laundry out of the dryer.
“End /
Anticrease” LED
is on.
* Program has come to an end.
* Turn off the dryerand take the laundry
out of the dryer.
“Filter cleaning”
LED flashes.
* Lint filter may not have been
cleaned.
* Clean the lint filter.
The “Drying”
LED flashes.
* A heat sensor failure has
occurred. dryer ends the program
without heating.
* Turn off the dryer and remove the
laundry. Call the authorized service.
For products equipped with a condenser
“Water tank”
warning LED on.
* Water tank may be full.
* Anti-creasing program might be
running.
* Drain the water from the water tank.
“Condenser
cleaning” LED
on.
* Condenser may not have been
cleaned.
* Clean the condenser.
A
Call an authorized service if the problem persists.
