![background image](http://html1.mh-extra.com/html/blomberg/7161549000/7161549000_user-manual_2774416011.webp)
11 / EN
Washer-Dryer / User Manual
3
2
1
1 Use a tool to
loosen all bolts until
they rotate freely.
3
2
1
2 Remove the transit
bolts by turning
them slightly.
3
2
1
3 Attach the plastic
covers supplied in
the user manual
bag into the holes
on the rear panel.
C
INFORMATION
• Keep the transit bolts in a safe place to
reuse when the product needs to be
moved again in the future.
• Never move the product without the transit
bolts properly fixed in place!
3.4 Connecting water supply
C
INFORMATION
• The water supply pressure required to run
the product is between 1 to 10 bars (0.1
– 1 MPa). It is necessary to have 10 – 80
liters of water flowing from the fully open
tap in one minute to have your product run
smoothly. Attach a pressure reducing valve
if water pressure is higher.
A
CAUTION!
• Models with a single water inlet should not
be connected to the hot water tap. In such
a case the laundry will get damaged or the
product will switch to protection mode and
will not operate.
• Do not use old or used water inlet hoses
on the new product. It may cause stains on
your laundry.
1
2
3
1 Connect the special
hose supplied
with the product
to the water inlet
on the product.
A
CAUTION!
• Ensure that the cold water connection is
made correctly when installing the product.
Otherwise, your laundry will come out hot
at the end of the washing process and
wear out.
1
2
3
2 Tighten the hose
nuts securely
by hand. Never
use a tool when
tightening the nuts.
1
2
3
3 Open the taps
completely after
making the hose
connection to
check for water
leaks at the
connection points.
If any leak occurs, turn off the tap and remove
the nut. Retighten the nut carefully after
checking the seal. In order to prevent the
water leaks, keep the taps closed when you
do not use the product.