![background image](http://html1.mh-extra.com/html/blomberg/7145845100/7145845100_user-manual_2774331008.webp)
8 / EN
Washing Machine / User Manual
4.1.4 Connecting the water supply
C
It is necessary to have 10 – 80 litres of water flowing from the fully open tap in one minute to have your machine run
smoothly. Attach a pressure reducing valve if the water pressure is higher.
A
CAUTION:
Models with a single water inlet should not be connected to the hot water tap. In such a case the laundry will
get damaged or the product will switch to protection mode and will not operate.
A
CAUTION:
Your drain house will be flooded if the hose comes out of its housing during water discharge. Moreover, there
is risk of scalding due to high washing temperatures! In order to prevent such situations and make sure that the machine
performs water intake and discharge processes without any problem, fix the drain hose securely.
• Connect the drain hose to a minimum height of 40 cm and a maximum height of 100 cm.
• In case the drain hose is elevated after laying it on the floor level or close to the ground (less than 40 cm
above the ground), water discharge becomes more difficult and the laundry may come out excessively wet.
Therefore, follow the heights described in the figure.
40 cm
100 cm
• To prevent the waste water siphoning back into the machine again and to ensure easy drainage, do not
immerse the end of the hose into the waste water or do not insert it into the drain for more than 15 cm. If it
is too long, cut it short.
• The end of the hose should not be bent, it should not be stepped on and the hose must not be pinched
between the drain and the machine.
• If the length of the hose is too short, add an original extension hose. Length of the hose may not be longer
than 3.2 m. To avoid water leak failures, the connection between the extension hose and the drain hose of
the product must be fitted well with an appropriate clamp as not to come off and/or leak.
4.1.6 Adjusting the feet
A
CAUTION:
In order to ensure that the product operates more silently and vibration-free, it must stand level and balanced
on its feet. Balance the machine by adjusting the feet. Otherwise, the product may move from its place and cause crushing
and vibration problems.
CAUTION:
Do not use any tools to loosen the lock nuts. Otherwise, they will get damaged.
1
Loosen the lock nuts on the feet by hand.
2
Adjust the feet until the product stands in a stable and balanced way.
3. Tighten all lock nuts by hand again.